HCVC Portable Calibrator


Portable Voltage / mA Calibrator designed to meet the requirements of field-calibration, testing, and troubleshooting of transducers, transmitters, actuators, and other process and control devices.

  • 0.59” (15 mm), LCD numerical display, with blue backlighting for use in dimly lit areas.
  • Powered by a readily available standard 9V battery, it also comes with a 120 V AC plug-in power supply for bench-top use.
  • Three output modes automatically selected by plug location.
  • Simulate using external loop supply (30 V DC Maximum).
  • Voltage-output.
  • Auto-ramping with user-adjustable minimum & maximum output values.
  • User-adjustable ramp step time, 1 to 20 seconds, in 1 second increments.
  • User-adjustable auto-power-off time from 1 to 20 minutes in 1 minute increments.
  • 3-Position bail for pocket, hanging, or bench-top use.



  • Manual: anywhere in range.
  • Auto: Values: user adjustable min. & max. values anywhere within range. Step Time: user adjustable from 1 to 20 seconds, in 1 second increments.


  • Numerical: LCD, 00.0 to 99.9, 0.59” H (15 mm).
  • Annunciators: “RAMP”, “OVER LOAD”, “mA”, “V”, “TIME”, and symbol for low battery.
  • Blue Backlight: energized with momentary side switch.


  • 9V Battery: NEDA1604, JIS006P, or IEC6F22 (Duracell MN1604 or equivalent); up to 30 hours continuous use.
  • Low Battery: indicator comes on below approximately 7 volts.
  • 120 VAC: plug-in 9VDC output supply for bench-top use.
  • Auto Power Off: user adjustable delay time from 1 to 20 minutes after last key press can also be disabled.


  • Operating temperature: 32 to 122°F (0 to 50°C).
  • Dimensions: 5.5”H x 2.5”W x 1.4”D (140H x 63.5W x 35.6D mm).
  • Weight: 6 oz (170 g).

Accessories: 9V battery, 120 VAC plug-in power supply, Test leads with alligator clips, Carrying case.


Extra Information

Meter Approvals
Digital Meter Type